What's new
What's new

Anyone still running CharD10?

Without going into the whole story I wound up with a D10 when my partner died. Mike always ran the machines for the little work we had for them I never paid much attention. Machine sat around for a year or so. Had time set it up and got it going. It was cutting very fast but terrible surface. I changed some settings got it going think showing 15 amps. Walked away couple minutes smoke from the cabinet resistors were very hot blew all the fuses on back and front top fan failed. Replaced fan and fuses set at 1/4 tried again blew some fuses. At 1/8 it sparks but will not cut just builds up a spike of carbon. Tried a bunch of stuff no luck. Any ideas?
Bob
 








 
Back
Top