Toolmaker84
Plastic
- Joined
- Feb 21, 2019
I have a Elox Futura 100 / Workmaster 45. I am in Gainesville Georgia. Does anyone know where to get a manual or any kind of operating instructions for this? Also is there anyone that has a contact to repair one of these
This machine was bought from an auction years ago and the wires were cut/disconnected without marking. I got that figured out (I think). I have got through most of the problems getting this to turn on (door switch was tripped) and getting the Z axis to stop moving continually on its own (a connection with several pins was disconnected inside the cabinet.
I am to the point to run the machine (I hope) and am looking for any info anyone has to offer. Like a "watch out for this" or "whatever you do don't do this"... Books / notes / videos...
Please help if you can even if it is not he exact model but one that is close.
Note: I have 12 years of machining experience but No EDM Experience
Thanks!
This machine was bought from an auction years ago and the wires were cut/disconnected without marking. I got that figured out (I think). I have got through most of the problems getting this to turn on (door switch was tripped) and getting the Z axis to stop moving continually on its own (a connection with several pins was disconnected inside the cabinet.
I am to the point to run the machine (I hope) and am looking for any info anyone has to offer. Like a "watch out for this" or "whatever you do don't do this"... Books / notes / videos...
Please help if you can even if it is not he exact model but one that is close.
Note: I have 12 years of machining experience but No EDM Experience
Thanks!