Hello.
We have one Agie Progress V3. But the machine have problems with the water level.
When we start to Run it, we put the Z Axis in to low position but the machine shows us a message in order to close the Second door because the water level needed is too high, and is a mistake. Even do we close it and it start to fill, but it never stop.
We changed potentiometer, Board ADC-18 and the Board DBE-10 ( Manufacture Recommendation) but the problem continues.
Do you have any idea about what else can we do?
Thanks.
Regards.
We have one Agie Progress V3. But the machine have problems with the water level.
When we start to Run it, we put the Z Axis in to low position but the machine shows us a message in order to close the Second door because the water level needed is too high, and is a mistake. Even do we close it and it start to fill, but it never stop.
We changed potentiometer, Board ADC-18 and the Board DBE-10 ( Manufacture Recommendation) but the problem continues.
Do you have any idea about what else can we do?
Thanks.
Regards.
