learning-as-I-go
Plastic
- Joined
- Sep 29, 2021
I've recently started using an Accutex wire EDM machine, and the post processor we use in MasterCAM adds in a M90 near the start of each program, and an M92 near the end. I can't find these commands documented anywhere in the (limited) machine manuals we've got, and I couldn't turn anything up by Googling (no one at the shop seems to know, either).
Does anyone know what these commands do? Should I put them in any gcode I write by hand, or can I omit them?
Does anyone know what these commands do? Should I put them in any gcode I write by hand, or can I omit them?