Wade C
Stainless
- Joined
- Jul 21, 2004
- Location
- Wiggins CO. USA
Have a '92 Mits DWC110-SZ that best I can tell, has a bad X/Y servo drive. Started with being sluggish/pulsing speed when positioning, then started giving an alarm at power up and would take a few power cycles before it would come up without an error and allow the "ready" button to activate. Now it shows no alarm (on maint-alarm screen or the alarm light on the panel) but when the ready key is pressed it makes noise like it came to ready and then back out - but the ready light never lights.
So, I guess Im at the point of looking into a repair place to get a price estimate, used drive, or bailing on the machine and selling as parts.
Any recommendations on repair places? Leads on a good used servo drive? Thoughts?
I have the FX10 running (new to me as of beginning of May), so Im not dead in the water, but would sort of like to have the SZ running if I can afford/justify it since its all fixtured up and so forth.
Wade
So, I guess Im at the point of looking into a repair place to get a price estimate, used drive, or bailing on the machine and selling as parts.
Any recommendations on repair places? Leads on a good used servo drive? Thoughts?
I have the FX10 running (new to me as of beginning of May), so Im not dead in the water, but would sort of like to have the SZ running if I can afford/justify it since its all fixtured up and so forth.
Wade