G-Auto
Hot Rolled
- Joined
- Nov 13, 2006
- Location
- Montco, PA
I picked up a Mitsubishi DCW-110 wire edm sn: 5911K822 from Ebay back in Jan. It belonged to the father of an ex Mits salesman. Nice guys and I saw the machine run before I purchased it.
Had the machine professionally rigged into my new shop and the fellow I purchased it from mechanically set it up but could not hook it up electrically as my 3 phase was not wired yet.
Several months later my power is up but the system program is gone. Since the seller has his money its like pulling teeth to get him out here. Finally I did but he could not get the system to load.
I have the manuals and I watched this guy follow the procedure to the letter. He seemed to think there was something he was missing but he could not remember it.
At this point I have given up getting this guy out here again as he will not return phone calls anymore.
Has anyone done the system load before on these machines and is there something that is not in the manual?
TIA
Had the machine professionally rigged into my new shop and the fellow I purchased it from mechanically set it up but could not hook it up electrically as my 3 phase was not wired yet.
Several months later my power is up but the system program is gone. Since the seller has his money its like pulling teeth to get him out here. Finally I did but he could not get the system to load.
I have the manuals and I watched this guy follow the procedure to the letter. He seemed to think there was something he was missing but he could not remember it.
At this point I have given up getting this guy out here again as he will not return phone calls anymore.
Has anyone done the system load before on these machines and is there something that is not in the manual?
TIA