mymachinery
Aluminum
- Joined
- Apr 4, 2007
- Location
- McBEE, SC
I hope someone has some experience with this problem: I got this new to me machine hooked up & running, but it only cuts very slow, around .012"/min in 1/2" steel. It did start cutting fast (.117"/min) one time, and I was so amazed that I stopped the machine to admire the work piece, and when I started cutting again it cut very slowly again. While cutting I have checked the voltage and it was corresponding to the control screen reading of 49V. I haven't found anywhere to check the amperage as the cables are all shielded. So far, I have checked the power feed contacts, dielectric resistivity,any fuse I can find, various circuit board cable connections,
Does anyone have any ideas? Pulling my hair out here
Does anyone have any ideas? Pulling my hair out here