Hello, I'm fairly new to Wire Edm and I'm having a problem with my RA-90, when I autothread the wire will thread fine and go through everything great but when the wire is done being threaded the guide pipe stays down and air keeps shooting out of it. I asked my service guy what to do and he told me to adjust the pipe holder in the back of the machine but after fiddling for an hour and a half I can't seem to get it to work. Anyone have any suggestions on what the problem could be? Just keep adjusting and testing or could it be something else?
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Mits RA-90 Guide Pipe not going back up after autothread
- Thread starter sweed76
- Start date
- Replies 0
- Views 786