i have a 2014 Mitsubishi MV2400S Wire EDM Machine that as a reoccurring Servo Alarm in the Y axis. it doesn't happen all the time but about every other week or so i have this issue, its always the Y axis, the irritating part about it is my wire path is well over .600 away from the table edge and it continues to throw this alarm every so often.
i have changed the battery's for all the servos. i have made sure the machines stays clean and no obstructions. Just trying to see if there is anything else i can look at to stop this from happening, we are trying to do overnight runs and about once a week ill have this same issue where it says sequence error, servo alarm S01 Y axis.
i have talked with service guy about this but his response is always that you must have hit or collided with something. but i know that is not the case.
any help?
i have changed the battery's for all the servos. i have made sure the machines stays clean and no obstructions. Just trying to see if there is anything else i can look at to stop this from happening, we are trying to do overnight runs and about once a week ill have this same issue where it says sequence error, servo alarm S01 Y axis.
i have talked with service guy about this but his response is always that you must have hit or collided with something. but i know that is not the case.
any help?