Hello all,
I am new to this forum and am not a trained machinist. Our company has just purchased a Mitsubishi wire EDM. My coworker at one point was a CNC machinist. We had received some training from the install tech but our training session was cut short. After the tech left, we wanted to do some more practice cuts. When we went to do an edge pickup we had a M672 UV ORIGIN NOT SET ERROR message. There wasn't any information about the error from the controller either. Any suggestions?
I am new to this forum and am not a trained machinist. Our company has just purchased a Mitsubishi wire EDM. My coworker at one point was a CNC machinist. We had received some training from the install tech but our training session was cut short. After the tech left, we wanted to do some more practice cuts. When we went to do an edge pickup we had a M672 UV ORIGIN NOT SET ERROR message. There wasn't any information about the error from the controller either. Any suggestions?