no, the external one. The problem is that my chiller is overheating. The compressor works all the time because the difference between the water temperature and the ambient temperature is too big. I can see on the digital screen +9.9 degrees Celcius and I should see +0.1..+ 0.2...You don’t have that on your machine?
There are 3 sensors visible from outside, one in water (lower part of chiller), the second one ambient air sensor in chiller (top, visible in mesh near display) and the external one which is attached to the machine body.
I can measure resistance and maybe you can find similar one.
I am clearly missing the one that is attached to the end of this wire (see photo). And yes if possible I would like to have the resistance of this sensor.
Example: 20 degrees celcius = 10 ohm
Hi Satsun,
I’m trying to get answers from Mike from jestertechnologies by phone or email and I don’t have any answers. He does not call back or email..... does he always offer a service? Thank you
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.