tvalenzuela1432
Aluminum
- Joined
- Oct 19, 2015
- Location
- Ontario, California
Just wanted so input on what would be causing a my flushing to sometimes be good and others not register much pressure at all through the "Down" flow meter. Even when the valve is wide open I'm barely getting much flow when there should be. My EPAC settings are for full flush and the "UP" flow meter has full flow but not the down one. We checked some of the valves and they all looked clean and good. Due to the fact it happens like 8 out of 10 runs per-say, I am leaning towards a solenoid not working right. I'm running a 5 inch tall gear type cut and the wire keeps breaking. I believe from poor flushing. Any one have any suggestions or knows exactly which valves/solenoids that directly affect the flow through the "DOWN" flow meter which I think...is the upper head flushing.
(Not sure if it directly related to this but when the AWF is active, I get bubbles with in the flow meter and it doesn't hold water in the flow meter at all times)
Thanks,
Tvalen1432
(Not sure if it directly related to this but when the AWF is active, I get bubbles with in the flow meter and it doesn't hold water in the flow meter at all times)
Thanks,
Tvalen1432