jptech
Aluminum
- Joined
- Jun 4, 2009
- Location
- NE Ohio, USA
Hi everyone, I hope you all had a great Thanksgiving, and you're all in good health!
I've got a problem with my 1996 310, and I'm hoping someone can help. Machine has been sitting for a few months since I last powered it up. I bought it used and it had sat for a few months before I got it. I've finally had time to get it going, so now the problems start showing up. Long story short, water is all fresh, new filters, conductivity is 15. Loaded software, and referenced all axes. When I got to do the wire calibration, there is no menu/command for it. I also noticed that I have no access to quite a few menus. I tried to enter the password - I'm positive that I saw a factory PW of 000000. The Help file says use machine serial #. Neither works, so I'm thinking that a previous owner changed it and didn't bother to record it anywhere. Has anyone had this kind of problem and can maybe give me some advice? Any help is appreciated! Thank You!!------------------ John
I've got a problem with my 1996 310, and I'm hoping someone can help. Machine has been sitting for a few months since I last powered it up. I bought it used and it had sat for a few months before I got it. I've finally had time to get it going, so now the problems start showing up. Long story short, water is all fresh, new filters, conductivity is 15. Loaded software, and referenced all axes. When I got to do the wire calibration, there is no menu/command for it. I also noticed that I have no access to quite a few menus. I tried to enter the password - I'm positive that I saw a factory PW of 000000. The Help file says use machine serial #. Neither works, so I'm thinking that a previous owner changed it and didn't bother to record it anywhere. Has anyone had this kind of problem and can maybe give me some advice? Any help is appreciated! Thank You!!------------------ John