Serrations programing on wire edm

Nero81 · Mar 5, 2019

I need to make serrations on one long part and wire edm is only machine that i can do it on. Machine is fanuc and I'm not good with g codes. Is there a code for repeating sections? Like i program one line or one serration and just add code that says repeat this 123 times?

SWISSguy89 · Mar 5, 2019

Nero81 said:
I need to make serrations on one long part and wire edm is only machine that i can do it on. Machine is fanuc and I'm not good with g codes. Is there a code for repeating sections? Like i program one line or one serration and just add code that says repeat this 123 times?

You need to do a incrementall program than copy paste 10 times then copy paste that 10 times

Sent from my LM-X410PM using Tapatalk

Nero81 · Mar 5, 2019

That could work. Thnx

SWISSguy89 · Mar 5, 2019

Nero81 said:
That could work. Thnx

If you have graph on your machine you could make a point or some geometry signifying the correct last point of cut at end of serations to be sure you dont cut one too many and verify

Sent from my LM-X410PM using Tapatalk

Nero81 · Mar 5, 2019

No needed, it can only go "in empty"

andrewmawson · Mar 5, 2019

There is a Post Processor in FeatureCAM that I use with my Fanuc Tapecut Model M to do such things.

Search

Largest Manufacturing Technology Community on the Web

Search

Serrations programing on wire edm

Nero81

Plastic

SWISSguy89

Banned

Nero81

Plastic

SWISSguy89

Banned

Nero81

Plastic

andrewmawson

Hot Rolled

Similar threads