Btriquetra
Plastic
- Joined
- Sep 27, 2017
Sodick Wire Burner AQ327L give "Wire Guide is Open" Error message on contact.
Hey guys, I've been having a lot of trouble with this wire burner lately and I'm hoping you can help me out.
I'm working with a Sodick AQ327L and every time I start a new program and the wire makes contact with the part it trips a "Wire Guide is Open" Error message. At that point, I usually just hit ENTER and it starts running and runs just fine for the entire program.
Just recently though, the burner has been burning a few thousands of an inch off. It has been acting as if I touched off on a zero corner in a sightly different location. Last time it was off .010 on the Y and .003 on the X.
I cant help but wonder if the two are related. If anyone help me out with this I would greatly appreciate it.
Hey guys, I've been having a lot of trouble with this wire burner lately and I'm hoping you can help me out.
I'm working with a Sodick AQ327L and every time I start a new program and the wire makes contact with the part it trips a "Wire Guide is Open" Error message. At that point, I usually just hit ENTER and it starts running and runs just fine for the entire program.
Just recently though, the burner has been burning a few thousands of an inch off. It has been acting as if I touched off on a zero corner in a sightly different location. Last time it was off .010 on the Y and .003 on the X.
I cant help but wonder if the two are related. If anyone help me out with this I would greatly appreciate it.