nlancaster
Aluminum
- Joined
- Oct 8, 2018
Hello,
I am new to wire EDM and we are cutting a slot that is about 4 inches deep and cuts into the material .125.
The slot at the top of the part is running .00985 and the slott at the bottom of the part is running about .00950.
So top to bottom the slot narrows about .00035.
.0060 wire running at 105 decameters per minute. Would increasing the wire speed reduce this taper?
I am new to wire EDM and we are cutting a slot that is about 4 inches deep and cuts into the material .125.
The slot at the top of the part is running .00985 and the slott at the bottom of the part is running about .00950.
So top to bottom the slot narrows about .00035.
.0060 wire running at 105 decameters per minute. Would increasing the wire speed reduce this taper?