Hi brand new here, but wondering if you guys can help. I have a fabricator working on a project for me and he’s having some difficulty. What we’re trying to do is emulate a Ferrari F12tdf exhaust tip assembly. The issue he’s having is getting the rolled edge on the holes where the tail pipes go in the perforated steel as in the original. He has a round dimple die, but given that the perforated piece is at an angle to the pipes going through, the cross section on the perforated piece is an oval. Any ideas other than having a custom dimple die made (impractical for a single use here) to get the same rolled edges on the perforated steel? Thanks.