dantech
Plastic
- Joined
- Nov 2, 2007
- Location
- Ontario Canada
I have an older Hypertherm 45 (2011) on a CNC plasma table with the proper machine torch. and Lately, I've been getting a torch cap fault in the middle of a job. Tried new consumables but the problem persists. The cutter works fine if I install the hand torch. I suspect a broken wire in the main cable. I am looking for a wiring diagram for the torch, or some way of bypassing this cap sensor. I don't want to buy another torch for this older machine because it just not worth it. I need to keep this thing going until I have the funds for a new machine.
Thanks for any help.
Thanks for any help.