Hello,
I have a Lincoln 256. I run it on 208 single phase. I have had it for about 3 years. We use it very rarely, as in still on original spool of wire.
We have 3 phase a the shop and have had several issues this summer with dropping a single phase of power. I am not sure if this is what caused the issue but when I turn it on the wire feed and volts readings really start to fluctuate and then I get an error HI LN1.
I was told the board needed replaced. Is this something that can be easily done or is there a calibration after installed?
I have a Lincoln 256. I run it on 208 single phase. I have had it for about 3 years. We use it very rarely, as in still on original spool of wire.
We have 3 phase a the shop and have had several issues this summer with dropping a single phase of power. I am not sure if this is what caused the issue but when I turn it on the wire feed and volts readings really start to fluctuate and then I get an error HI LN1.
I was told the board needed replaced. Is this something that can be easily done or is there a calibration after installed?