todd goff
Hot Rolled
- Joined
- Feb 8, 2007
- Location
- south carolina
I am working on a c & g systems aviator plasma table trying to get it running but not having any luck. I went into the service mode to get my encoder counts for x and y and they are gone. I don’t know where they are gone to but they have vanished. Does anyone on here have a burny 1250 and if so could I beg you to pull up service mode and post the encoder settings PLEASE. The motors are 5 volt dc Cleveland motion controls and encoders are encoder products. If further info. Is needed let me know and I can post part # s, serial numbers or whatever. Thanks in advance.