Good morning,
I recently picked up a small pneumatic hammer to use in my forging process. I saw a video here a while back about a guy in Europe who uses one of these to do ornamental forging and surface texturing.
I am attaching 2 photos. The hammer is an Ingersoll Rand K1. It is quite old and I can't find much info about its use on-line.
My question: How do you open this up to install the bits? Is there a trick to it? It would seem to unscrew, but won't budge. I don't want to damage it. Thanks, Tom from Mass.
I recently picked up a small pneumatic hammer to use in my forging process. I saw a video here a while back about a guy in Europe who uses one of these to do ornamental forging and surface texturing.
I am attaching 2 photos. The hammer is an Ingersoll Rand K1. It is quite old and I can't find much info about its use on-line.
My question: How do you open this up to install the bits? Is there a trick to it? It would seem to unscrew, but won't budge. I don't want to damage it. Thanks, Tom from Mass.