West-7
Aluminum
- Joined
- May 24, 2019
I've got a older sync 350 I picked up last summer that's been great. I put the welder into service immediately after acquiring it and really like it.
When I start the machine at idle with the amperage knob turned over 20% the voltage sits at 64.5. Shouldn't this be at 0 when I'm not welding?
Is there any maintenance that I should be doing to this machine? I was thinking about popping all the covers off and at least blowing the dust out. Would spraying anything with electrical contact cleaner with a lubricant or cleaning up any connections be beneficial? Are there any components inside that should be replaced due to age?
When I start the machine at idle with the amperage knob turned over 20% the voltage sits at 64.5. Shouldn't this be at 0 when I'm not welding?
Is there any maintenance that I should be doing to this machine? I was thinking about popping all the covers off and at least blowing the dust out. Would spraying anything with electrical contact cleaner with a lubricant or cleaning up any connections be beneficial? Are there any components inside that should be replaced due to age?