Thermal Arc 350 Ultra Flex CC/CV Connected to Lincoln LN-7 Wire Feeder
Login to Your Account
Likes Likes:  0
Results 1 to 1 of 1
  1. #1
    Join Date
    Jul 2015
    Post Thanks / Like
    Likes (Given)
    Likes (Received)

    Default Thermal Arc 350 Ultra Flex CC/CV Connected to Lincoln LN-7 Wire Feeder

    Very cautiously working towards hooking up a LN7 wire feeder to my Thermal arc base welder. Have ordered the Amphenol connector.

    I have attached photographs of what I think are the relevant parts of the respective wiring components. I have full schematics that I could post as well if requested.

    BASE WELDER (Amphenol 19 Pin Connector)(only detailing pins that had a wire soldered).

    Pin A (red) Contactor Ckt. (+15v)
    Pin B (brn) Contactor Ckt. (A-B closure turns power source on)
    Pin E (blk) 120 VAC
    Pin F (wht) 120 VAC Neutral
    Pin G (grn) Chassis Frame Ground


    D 115 VAC
    C 115 VAC
    F Work
    B To Contactor Circuit
    A to Contactor Circuit
    E Ground

    Questions (very basic):

    Is wire feeder E Ground the same as Pin G Chassis Frame Ground?

    Is wire Feeder wire F Work the large welding cable that hooks to the work to be welded?

    The Wire D & C 115 VAC of the FEEDER does not specify which one is Neutral, How can I figure which is nuetral so I can hook it up to the nuetral of 120 VAC neutral of the WELDER?

    The Wire B & A to Contactor Circuit of the FEEDER does not specify which is positive, nor the voltage. Does the order, or voltage, matter when I hook it up to the corresponding two wires on the WELDER?

    Any details or suggestions would be appreciated.


Tags for this Thread


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts