Christopher81
Plastic
- Joined
- Sep 16, 2021
Water jet etching creates "comet tails" on traverses after a etched character
I created a little test widget to check taper, cut quality, and etching on stock. In this case it's 0.25" 304 Stainless. But the etched numbers all end in a tail that fades out over an half inch or so. In the tool path these are traverses. Any ideas on how to resolve this?
I created a little test widget to check taper, cut quality, and etching on stock. In this case it's 0.25" 304 Stainless. But the etched numbers all end in a tail that fades out over an half inch or so. In the tool path these are traverses. Any ideas on how to resolve this?