tnmgcarbide
Diamond
- Joined
- Jul 6, 2004
- Location
- N. GA- 33.992N , -83.72W usa
'been tinkering w/ a cheap digi caliper's spc jack.
the jaws are worn from abuse ( my mti's still pretty + clean) , and i'm wondering if there's
any other useful application for this once $9.99
flea market special.
has anyone used it as a remote for a machine -mounted ,similar scale.... can two scales
interface thru the 4-pin port(negV,data,clock,posV)...is this possible?
or would that destroy both tools? or is another
device required between the two readers...
otherwise, it'll make a fine quill-DRO for my mill.
the jaws are worn from abuse ( my mti's still pretty + clean) , and i'm wondering if there's
any other useful application for this once $9.99
flea market special.
has anyone used it as a remote for a machine -mounted ,similar scale.... can two scales
interface thru the 4-pin port(negV,data,clock,posV)...is this possible?
or would that destroy both tools? or is another
device required between the two readers...
otherwise, it'll make a fine quill-DRO for my mill.