I purchased an Enco 4" Kurt clone vise about 4 years ago. It was not perfect, but for the type of service I used it for (HSM model engines) on my mill/drill it was ok. Later, I flycut the base and that improved it. I used it until about a year ago when I replaced it with another Enco vise. This one is a 5" model that is marked as an "Elephant" brand vise. It is a much better quality, I presume, Chinese made vise. It is quite accurate and I have had no problem with this vise. I didn't even bother to purchase the swivel base since I rarely ever used the one on the 4" model. For homeshop, occassional use, this vise is more than adequate especially for the $75 (and free shipping) that it cost. When I buy that Bridgeport I have always wanted, I will get a real Kurt.