Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Machining method
- Thread starter barlow L
- Start date
- Replies 3
- Views 1,087
L Vanice
Diamond
- Joined
- Feb 8, 2006
- Location
- Fort Wayne, IN
The rectangular pocket could be done by forging or cold forming, if it is all one piece. It could be silver brazed from two pieces.
Larry
Larry
Mike C.
Diamond
- Joined
- Nov 25, 2004
- Location
- Birmingham, AL
Clean it out really good and you can probably see enough tool marks to figure it out. It was probably cut as far as possible with an endmill or plain horizontal cutter and then the corners cut out with a diamond point chisel, just like squaring the corners of a hinge on a wooden door after routing.
