Michael C
Cast Iron
- Joined
- Oct 4, 2002
- Location
- Lane County, Oregon
Making up some BXA toolholders. Before I have cut the dovetail with a homemade tool using tnmg insert, it works but it hammers being a single cutter.
I was going to bite the bullet and buy a 60 degree HSS DT cutter from Enco but am unsure which one to purchase.Two choices that seem in the neighborhood are :
3/4" cutter diameter, 3/8" shank, 5/16" cutter width
or
1 3/8" cutter diameter, 5'8 shank, 9/16" cutter Width.
Any thoughts on if I can get buy with the smaller, less expensive one, or should I go with the 1 3/8" model.
Thanks
Michael
I was going to bite the bullet and buy a 60 degree HSS DT cutter from Enco but am unsure which one to purchase.Two choices that seem in the neighborhood are :
3/4" cutter diameter, 3/8" shank, 5/16" cutter width
or
1 3/8" cutter diameter, 5'8 shank, 9/16" cutter Width.
Any thoughts on if I can get buy with the smaller, less expensive one, or should I go with the 1 3/8" model.
Thanks
Michael