1/4" Hex Drive Quick Release w/o Wobble

goldenfab · Nov 13, 2018

Does anyone know if there is a quick disconnect 1/4" hex drive that locks in tight for good run out and no wobble? Ultimately what I'm trying to achieve is a quick disconnect for 1/8" router bit to/from a power tool.

DDoug · Nov 13, 2018

Seeing how there have been no responses....as a temp bodge, you could
take a little piece of electrical tape (just cut a square)

Put it over the end of the shaft, and shove it into the tool.
It will wrap up around the sides, and take up allot of the
gap.

metalmagpie · Nov 14, 2018

digger doug said:
Seeing how there have been no responses....as a temp bodge, you could
take a little piece of electrical tape (just cut a square)

Put it over the end of the shaft, and shove it into the tool.
It will wrap up around the sides, and take up allot of the
gap.

Nah, tape isn't the best way. Ya gotta get with CHEWING GUM.

dsergison · Nov 15, 2018

copy the threaded shank aircraft drills?
Aircraft & Sheet Metal Tools UK : Threaded Shank Drill Bits - Tel: +44 (0) 1698 426662

Search

Largest Manufacturing Technology Community on the Web

Search

1/4" Hex Drive Quick Release w/o Wobble

goldenfab

Cast Iron

DDoug

Diamond

metalmagpie

Titanium

dsergison

Diamond

Similar threads