I got a quote for a 3x2x .5 inch pieece of carbide that has a .50 hole in the middle with an 82 degree c sink with a .03 chamber on all sides. Iv never worked with carbide before but I imagine it would have to be ether ground or edm? My surface grinder only has aluminum oxide and cbn wheels.
The tolerance for every thin id 2 grand except the hole that's 10 grand.
I do have a ram edm.
Can you get precession size stock for carbide?
How much would you price a job like this?
Is it even worth doing if I have limited knowledge of working on carbide?
The tolerance for every thin id 2 grand except the hole that's 10 grand.
I do have a ram edm.
Can you get precession size stock for carbide?
How much would you price a job like this?
Is it even worth doing if I have limited knowledge of working on carbide?