lewrssll83
Plastic
- Joined
- Apr 1, 2021
Good afternoon guys!
fist post here and what a forum. its quite a mammoth amount of information.
I do have a problem and I suppose that's what leads a lot of people here.
i have the AMADA HA-500 horizontal saw and what its recently started doing is the rear clamp for holding the job has opened once the saw starts to come down...it should do this, but it should reclose to clamp the job.
so i turn it on, front clamp closed, rear closed. then press start and the rear clamp opens and should re shut so the job doesn't slip but it just stays open. the saw must be about 30 years old?
if anyone has one and has had this fault please could you assist and let me know what you did or if you have a manual as i have nothing here.
cheers
Lewis
fist post here and what a forum. its quite a mammoth amount of information.
I do have a problem and I suppose that's what leads a lot of people here.
i have the AMADA HA-500 horizontal saw and what its recently started doing is the rear clamp for holding the job has opened once the saw starts to come down...it should do this, but it should reclose to clamp the job.
so i turn it on, front clamp closed, rear closed. then press start and the rear clamp opens and should re shut so the job doesn't slip but it just stays open. the saw must be about 30 years old?
if anyone has one and has had this fault please could you assist and let me know what you did or if you have a manual as i have nothing here.
cheers
Lewis