scphantm
Cast Iron
- Joined
- Jul 15, 2004
- Location
- Pittsburgh, PA
I need to put some 90 degree bends in some home depot aluminum flat bar. i know if i try without annealing it first, it will crack. but currently my shop is sitting in a storage unit 200 miles away. Will a plane old plumbers torch get hot enough to anneal this stuff for bending?
I was going to use the old trick of mark it up with a sharpie and heat it till the sharpie burns off. Just don't know if i have enough heat.
butane in the plumbers torch maybe?
I was going to use the old trick of mark it up with a sharpie and heat it till the sharpie burns off. Just don't know if i have enough heat.
butane in the plumbers torch maybe?