kb1cjp
Aluminum
- Joined
- Nov 14, 2012
- Location
- Connecticut
I was planing on making an adapter from a straight thread to an NTP thread out of some brass hex bar. However I am having trouble IDing the thread. It is a temperature switch off of a Kubota block. See posted picture. I was guessing it would be metric, but can’t match anything.
This is what I measure:
Major Diameter 0.65”
Minor Diameter 0.57”
More course than 20tpi
Less course than 18tpi
More course than 1.25mm pitch
Less course than 1.5mm pitch
Any help would be much appreciated!
Thanks! Brian
This is what I measure:
Major Diameter 0.65”
Minor Diameter 0.57”
More course than 20tpi
Less course than 18tpi
More course than 1.25mm pitch
Less course than 1.5mm pitch
Any help would be much appreciated!
Thanks! Brian