ThisIsShopLife
Plastic
- Joined
- Oct 31, 2017
I have a job coming up where I will need to bore a .375 diameter into my chuck jaws. It is not a production job so investing in a collet chuck is out of the question. Curious if anybody has recommendations on best practices and tooling for this as I have zero experience boring jaws to less than 1.250. Some of my thots have been just drilling them using .375 carbide drill, live milling with small endmill, or miniature boring bars etc.
Lathe has live tooling and Y-axis.
Part tolerances are +/-.005 on OD.
Thanks !
Lathe has live tooling and Y-axis.
Part tolerances are +/-.005 on OD.
Thanks !