Karl_Kunkle
Aluminum
- Joined
- Mar 3, 2011
- Location
- Wilmington, delaware
Hi,
I have a couple of 5/16" diameter cat 40 heat shrink holders with carbide tools broken off flush with nose. The through hole is only 1/16". I'm trying to save the holders.
I have a haimer induction shrink fit station.
I tried double heating nose and banging it out. That failed. Next was double heating holder while chilling the the bore with cold air and water. Failed.
1st thought of having the tool burned out with edm. That was shot down by edm operator.
Any ideas? Thanks
I have a couple of 5/16" diameter cat 40 heat shrink holders with carbide tools broken off flush with nose. The through hole is only 1/16". I'm trying to save the holders.
I have a haimer induction shrink fit station.
I tried double heating nose and banging it out. That failed. Next was double heating holder while chilling the the bore with cold air and water. Failed.
1st thought of having the tool burned out with edm. That was shot down by edm operator.
Any ideas? Thanks