Never ran or ever seen one in person, got an opportunity to pickup a Mikron 102.05 universal for 5k with lots of change gears. Also have a project that it could be used for to make transmission shaft and 2 different smaller helical gears(which I have no doubt it can) My question is when a hobb machine is rated for say 5" of gear can the machine hold say a 12-14" shaft and hobb a 2" spline? Every vid online(and there limited) shows small gears between centers and I would think theres other methods to hold atleast the drive end ie collets.
I'm sure this is a dumb question so take mercy on my ignant a$$.
Regards,
Lock
I'm sure this is a dumb question so take mercy on my ignant a$$.
Regards,
Lock