HI I have a Cincinnati Horizontal mill, after running for a couple of hours it just cuts out, leave it for 10 mins and you can re start it again, then it keeps doing in through the day. any idea's
I think Andy is on the mark. Either the heater coils are for the wrong supply voltage, or the heater coils (after many decades) have deteriorated, or you have a chronic overload situation (perhaps a shorted motor coil or seized bearing).
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.