I do have a manual on this newly acquired lathe. I have the following questions.
The lathe came with a live center in the tail stock, and the manual says it’s supposed to be a #2 Morse taper. The question is how is the live center and taper properly removed so I could insert a drill chuck?
I have several (4”,4.5”,6”,8”) 3&4 jaw chucks from a Logan 9B that I may want to use. The Clausing spindle is 1-3/4” x 8 TPI. The question is where or who carry’s a supply of backing plates (preferably finished)?
The upside to this piece of equipment is outside of needing cleaning it is in very good condition and also included a tool grinder and Palmgren 250 milling attachment.
Any pointers and hints are welcomed.
The Logan 9B will be listed for sale in near future.
Thank you
The lathe came with a live center in the tail stock, and the manual says it’s supposed to be a #2 Morse taper. The question is how is the live center and taper properly removed so I could insert a drill chuck?
I have several (4”,4.5”,6”,8”) 3&4 jaw chucks from a Logan 9B that I may want to use. The Clausing spindle is 1-3/4” x 8 TPI. The question is where or who carry’s a supply of backing plates (preferably finished)?
The upside to this piece of equipment is outside of needing cleaning it is in very good condition and also included a tool grinder and Palmgren 250 milling attachment.
Any pointers and hints are welcomed.
The Logan 9B will be listed for sale in near future.
Thank you