sneebot
Stainless
- Joined
- May 14, 2001
- Location
- Massachusetts
I need to cut (trim) a lot (think 15000 or so) of small (0.01" diameter)
stainless steel wires. I've done some trials with a TIG torch which
leads me to believe that cutting them with some sort of power supply might
work well for this application.
Has anyone cut small wires in this way? What type of equipment did you use?
I was using somewhere between 2 and 15 amps (setting on the welder).
stainless steel wires. I've done some trials with a TIG torch which
leads me to believe that cutting them with some sort of power supply might
work well for this application.
Has anyone cut small wires in this way? What type of equipment did you use?
I was using somewhere between 2 and 15 amps (setting on the welder).