What's new
What's new

Dedtru Model C Manual needed

Yes, i have one. A little tattered and oil stained, but I think it is complete. Its only about 30 pages. Send me an email address and I scan it and send it.
 
A dental equipment manufacturer I did work for had a Dedtru for grinding the ODs of the little gears in right angle handpieces. One day they called me to help figure out why the gears would go through for the roughing pass but not for the finish. We soon determined that they had become magnetized. People were spinning all sorts of theories about alignment with earth's magnetic field, etc. When we ran a test piece, it dropped in the pan at a spot difficult to reach and the girl who was the normal operator said "I'll get it.", pulled a magnet out of a pocket, then stood there wondering why all these men were staring at her.

Bill
 








 
Back
Top