JasonPAtkins
Hot Rolled
- Joined
- Sep 30, 2010
- Location
- Guinea-Bissau, West Africa
Hi all, after sitting for a couple of months, my DoAll blade welder has developed a problem where, when connected to the wall, it's got a short. The thing I can't figure out is, it's shorting with everything off (no blade in the jaws, no tension on the jaws, flash grinder off, etc). I opened it up and don't see any chafed wires, parts that should be moving that aren't, bad contacts, etc.
Any advice? I have the manual but it doesn't include a troubleshooting section.
Thanks!
Any advice? I have the manual but it doesn't include a troubleshooting section.
Thanks!