xa-mont
Hot Rolled
- Joined
- Apr 4, 2014
- Location
- Victoria, Australia
Hey guys,
Had an issue with my new to me Mazak MP630 chuck not actuating - long story short the issue is a stuck draw tube (probably due to a life of cast iron machining)
I've managed (after a LOT of swearing and anger) to remove both the chuck and the actuator, so all that is now left is the draw tube up inside the spindle.
I made a plate to bolt the the spindle nose to push against the draw tube, in the hopes that i could make it move, but instead all i did was dish a piece of 12mm 250gr steel.
Any tips at this stage?
Had an issue with my new to me Mazak MP630 chuck not actuating - long story short the issue is a stuck draw tube (probably due to a life of cast iron machining)
I've managed (after a LOT of swearing and anger) to remove both the chuck and the actuator, so all that is now left is the draw tube up inside the spindle.
I made a plate to bolt the the spindle nose to push against the draw tube, in the hopes that i could make it move, but instead all i did was dish a piece of 12mm 250gr steel.
Any tips at this stage?