Any good ideas on how to do the central bulge on this in an economically efficient way (I'm looking to produce only a few of these, so $1000s in new tooling isn't in the cards).
The material will be cromoly steel, seamless, wall thickness of about 0.035 in., thicker if I need to go that way to get the radius bends without kinking on my JD2. Starting diameter is 1 in., expanded section is 1.25 in. May also try some aluminum, thicker walls.
Appreciate advice,
jb
The material will be cromoly steel, seamless, wall thickness of about 0.035 in., thicker if I need to go that way to get the radius bends without kinking on my JD2. Starting diameter is 1 in., expanded section is 1.25 in. May also try some aluminum, thicker walls.
Appreciate advice,
jb