Hi,
I recently bought mill which had tool holders but no tools. One of them were face mill arbor so I measured the shank diameter and bought face mill to it. However just noticed that the arbor is missing the keys or what ever they are called. I tried googling but no luck, can't find any. Is the only option to make them or where could these be found?
Arbor is BT30 and key should be 8mm wide. There seem to be M3 thread on arbor to hold the keys.
Thank you.
I recently bought mill which had tool holders but no tools. One of them were face mill arbor so I measured the shank diameter and bought face mill to it. However just noticed that the arbor is missing the keys or what ever they are called. I tried googling but no luck, can't find any. Is the only option to make them or where could these be found?
Arbor is BT30 and key should be 8mm wide. There seem to be M3 thread on arbor to hold the keys.
Thank you.