I'm thinking of facing the bed of my mill shaving off 0.1mm or so. The bed is quite old and worn, and prone to rusting, hard to clean properly and so on. The size is around 1500mm x 750mm.
Is this a good idea, and what do I need to think of? Obviously this would be a "no fail allowed" job. What are these commonly made out of? Current table Z is -824.9mm. (Supposed to be -825mm.)
Is this a good idea, and what do I need to think of? Obviously this would be a "no fail allowed" job. What are these commonly made out of? Current table Z is -824.9mm. (Supposed to be -825mm.)