crossthread
Titanium
- Joined
- Aug 5, 2004
- Location
- Richmond,VA,USA
I recently picked up this job and I could use some fixturing advice. First of all, this part is no longer available. I can think of a few ways of doing this but none stick out as the best procedure. I thought I might mount the swing arm on the mill table and bore out all but a little of the original journal and leave that half moon as a reference point. I could bore it all off and then line bore the new journals and hope for the best. I have at my disposal mill, lathe and TIG. I worry about when I flip this thing over to bore the second journal, what would I indicate off to make sure everything is in alignment. Thanks for any suggestions.