Hi, I have an amilam 350+ 3 axis digital readout what I would like to install on my lathe.
The unit has some issues I would like to resolve. The X axis works, but the Y and Z axis give no reading. the problem is in the unit selve.
When I try setting the device from will tho lathe, the display blinks and the device stays in mill.
It looks like a software failure but i'm not sure.
Has somebody any sugestions?
Thanks
The unit has some issues I would like to resolve. The X axis works, but the Y and Z axis give no reading. the problem is in the unit selve.
When I try setting the device from will tho lathe, the display blinks and the device stays in mill.
It looks like a software failure but i'm not sure.
Has somebody any sugestions?
Thanks
