Terry Keeley
Titanium
- Joined
- Oct 18, 2005
- Location
- Toronto, Canada eh!
I need to bond some 0.025" 3003 aluminum to fiberglass composite board (Coosa board) for trailer doors.
Thought about contact cement but I hate that stuff, if it ain't perfectly aligned the parts are trashed.
Also thought about 3m polyurethane adhesive but it's not thin enough to roll or brush.
https://www.3mcanada.ca/3M/en_CA/p/d/b40066983/
Would like something I can move the aluminum a bit for alignment before it sets up. Parts are roughly 5' x 18" each.
Any suggestions?
Thought about contact cement but I hate that stuff, if it ain't perfectly aligned the parts are trashed.
Also thought about 3m polyurethane adhesive but it's not thin enough to roll or brush.
https://www.3mcanada.ca/3M/en_CA/p/d/b40066983/
Would like something I can move the aluminum a bit for alignment before it sets up. Parts are roughly 5' x 18" each.
Any suggestions?