Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
how i made my lathe chuck spider
- Thread starter celsoari
- Start date
- Replies 11
- Views 2,534
steve45
Stainless
- Joined
- Jan 16, 2012
- Location
- Midland, Texas
I like your videos! Simple and easy to follow, and the music is pleasant. Keep up the good work!
StinkyDan
Aluminum
- Joined
- Jun 6, 2016
- Location
- Outside chicago
Post pictures. Or a descripiton would be cool too
rons
Diamond
- Joined
- Mar 5, 2009
- Location
- California, USA
Since you are open to suggestions:
The way you cut off the aluminium corners with a long exposed blade close to your hands/arms is highly dangerous. Use a guard.
The way you cut off the aluminium corners with a long exposed blade close to your hands/arms is highly dangerous. Use a guard.
thanks for the tip friend
Bluejeep
Hot Rolled
- Joined
- Aug 3, 2006
- Location
- Cape Cod, Ma
That is the most frightening vertical saw setup in use I have ever seen.
Bluejeep
Hot Rolled
- Joined
- Aug 3, 2006
- Location
- Cape Cod, Ma
At least fab up a blade guard and get a contouring blade. the blade you have mounted looks to be just for strait cuts.
Meh...I do this frequently.
Guard ? where is one needed ?
Hands are not on the cut line.
Yes, the blade width is too wide, and yes the OP horsed it a bit much (note under lower guide blade is moving
from too much pressure).
And yes, blade catches once or twice, but not much harm done
and piece is roughed out quickly, ready for lathe.
