Terry Keeley
Titanium
- Joined
- Oct 18, 2005
- Location
- Toronto, Canada eh!
I have a project that uses 1/16" dowel pins in 6061, they're a couple tenths over nominal as usual.
For some reason my 1/16" straight flute reamer is cutting big, the pins fit but just go right in. I've checked and don't see any burrs on the cutting surfaces, I've even run a stone down them to make sure. If it wasn't Sunday I'd just get a new reamer.
Any way to make it cut a few tenths smaller?
For some reason my 1/16" straight flute reamer is cutting big, the pins fit but just go right in. I've checked and don't see any burrs on the cutting surfaces, I've even run a stone down them to make sure. If it wasn't Sunday I'd just get a new reamer.
Any way to make it cut a few tenths smaller?